Digicom COMSPHERE 3911 Uživatelská příručka stáhnout pdf (Strana 169)

Device Management

7-21

6700-A2-GY31-70

July 1999

Disable

Choose Disable from the Commands pull-down menu to disable a DSU or APL

transmitter; DBM; or the TDM, MSM, or MCMP ports. This command is not

available if the selected device or port is already disabled. A message box

appears to announce the completion of the request.

Enable

Choose Enable from the Commands pull-down menu to enable a DSU or APL

transmitter; DBM; or the TDM, MSM, or MCMP ports. This command is not

available if the selected device or port is already enabled. A message box

appears to announce the completion of the request.

External Leads

Choose External Leads from the Commands pull-down menu to either display the

state of the four general purpose leads or to change the state of the two output

leads on the EIA-232-D/V.24 interface. When you choose External Leads, the

External Leads window appears.

The current state of the external leads is read from the device and appears in the

drop-down list box. You can change the value, either On or Off, if desired.

Choose Display to read the current state of the external leads from the device.

Choose Update to send the current value of the output leads as shown to the

device.

NOTE:

This command is not applicable to a Dial device within a carrier.

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 270 271

Žádné komentáře

Digicom COMSPHERE 3911 Uživatelská příručka Strana 169